Linear Slides

Page 36 Specifications subject to change without notice or incurring obligations “SE”Series Linear Slides 12-16 -98 Step 1 Indicate “SE” series. Select model size based on guide shaft dia. Select a stroke (Special strokes also available) Model Size 250 375 500 625 750 1000 1500 Bore 1/2" 3/4" 1-1/8" 1-1/8" 2" 2-1/2" 3-1/4" Guide Shaft Diameter 1/4" 3/8" 1/2" 5/8" 3/4" 1" 1-1/2" Contact Surfaces Totally Enclosed Adjustment Rod Adjustment Nut with Mating Fine Pitch Thread Stop Flange Plastic Plug Lock Screw Adjustment Nut Skirt Stop Tube .50" Min. Clearance when Fully Stroked Fabco-Air's popular Dial-A-Stroke ® can be applied to most SE Series models for precise adjustability of extend strokes. Operator Safety – The stop tube, adjustment nut with skirt, and minimum clearances combine to eliminate pinch points. Construction – An adjusting screw with a thread sealing locknut mounted in the rear end cap provides a simple, yet rugged adjustment of the cylinder stroke in the retract direction. The fine thread of the adjusting screw provides precision adjustment. Alternate Adjustable Extend Stroke Alternate Adjustable Retract Stroke Rear Piston Rod Extension This special configuration consists of a modified rear end cap with rod seal and an extended piston rod, allowing various special application uses. By adding a simple compression spring and clamp collar, a vertical load can be held in mid- position and powered either downward or upward. in place without damaging the threads. Precision adjustment is achieved with fine pitch threads on the adjustment rod. The stop flange is mounted on the end of the adjustment rod so the nut will not come off during adjust- ment. Adjustment – Adjustment settings are simplified by convenient scale markings. The stop tube is black anodized alumi- num – the adjustment nut is blackened steel with a black anodized aluminum skirt – the stop flange is red anodized aluminum: all for corrosion resistance and appearance. The adjustment nut, steel for long life, includes a lock screw with a plastic plug so the adjustment nut can be locked Other uses include special sensing and/or position feedback devices attached to the extended piston rod. An extended rear piston rod added to a tandem cylinder option allows the slide to have a mid-position adjustment capability. Model SE250 SE375 SE500 SE625 SE750 SE1000 SE1500 Standard Stroke Length 1/2" to 4" by 1/2" increments 1" to 6" by 1" increments 1" to 10" by 1" increments 1" to 10" by 1" increments 1" to 6" by 1" increments 8" to 18" by 2" increments 1" to 6" by 1" increments 8" to 20" by 2" increments 2" to 30" by 2" increments Specials SE500 – 5.0

RkJQdWJsaXNoZXIy NDI5NDE=