Linear Slides

Page 40 Specifications subject to change without notice or incurring obligations Floating Rear Bearing Block Option ( NOT available on EZ250) Puts maximum stroke within shortest possible envelope. To order: add “FRBB” after end cap mounting style and specify dimension “D”. Ordering example: EZ500 – 5.0 – MH2 – FRBB (D3.5) Options available: Sensing options are limited to magnetically operated "E" & "J" Options. Tooling, Stop, and Shock options are NOT available. “EZ” Series Linear Slides EZ 750 – 5.0 ( – ) Step 1: Basic Slide Model Step 1 Select a slide model size, stroke length, endcap mounting style, plus any optional toolbar, mounting bar (B1) or integral option (such as Viton seals, etc.). Helpful hint: The model size = guide shaft diameter in 3 decimal places. Stroke Series OPTIONAL TANDEM CYLINDER STROKE Standard Stroke Length 1/2" to 4" by 1/2" increments 1" to 6" by 1" increments 1" to 10" by 1" increments 1" to 10" by 1" increments 1" to 6" by 1" increments 8" to 18" by 2" increments 1" to 6" by 1" increments 8" to 20" by 2" increments 2" to 30" by 2" increments Model Size 250 375 500 625 750 1000 1500 – Order Guide Bore 1/2" 3/4" 1-1/8" 1-1/8" 2" 2-1/2" 3-1/4" Guide Shaft Diameter 1/4" 3/8" 1/2" 5/8" 3/4" 1" 1-1/2" Ordering example: EZ750 – 5.0 – 2.0 – MH2 – S03B – RC01CB Sensor locations – use “ M ” in the Box ( ) if mid-position sensor is required (3 sensors). Note: “ M ” (mid-position) is not available with “ S50, S51, S60 ” sensors. All sensors are located on the primary cylinder, which also contains the magnetic piston band for “ E ” & “ J ” options. Mid-position “ M ” prox sensor is not available on “ EZ375 ” models with “ S01 ” through “ S47 ” prox options (consider using “E” style sensors if mid-position sensing is required). Port Locations: Top ports are standard on all tandem models. A top and bottom port combination is available for the EZ500 and EZ625 as a “special” order at no additional charge. Consult factory. Secondary Cylinder Stroke Primary Cylinder Stroke 3-Position Tandem Cylinder Slides (Not available on SE250) Note: See pages 28 & 29 for principle of operation ▼ Rear floating bearing block can be positioned anywhere along the cylinder tube. See details on page 47. 1-8-99 To Order with Slide: Add “B1” to mounting style Example: EZ500 – 5.0 – MV1 B1 Optional “B1” Mounting Bars For use with MV1 or MV2 Mounting style D Rear Bearing Block Front Bearing Block Model Size Cut-away view of EZ625 tandem slide Primary stroke cylinder Secondary stroke cylinder

RkJQdWJsaXNoZXIy NDI5NDE=